RETRÖ Fittings set UPDATE


The location of the installation holes in the hanger has been changed so that the upper installation hole has been moved 20 mm higher (in the picture hole no. 1).

In addition to this, 2 pcs (3M VHB 155 x 35 mm) tapes have been added to the package, which are used ONLY if the door can be attached to the door’s supporting structure with only one bolt.




In addition to the current wall brackets (34 mm), 40 mm long brackets (2M: 5 pcs. and 2.4M 6 pcs.) have been added to the series. Longer brackets push the center line of the door 6 mm further from the wall. This allows the skirting board to be used even on slightly thicker doors.



One bottom guide added to the set. Basically, one bottom guide is always used, but two bottom guides can be used on both sides of the door, example if there is no groove in the door or you don’t want to make a groove in it where the bottom guide runs. The height of the bottom guide has also been changed from 24 mm > 20 mm, which leaves a lower gap between the floor and the door, and enables a shallower groove to be milled into the door. Also the screws (2 pcs, 4.2 x 25 mm) and fixing plugs (2 pcs 5.5 x 20 mm) has been updated.



  • RETRÖ fittings set 2 meter: 11700-0
  • RETRÖ fittings set 2,4 meter: 11701-0


From the link below, you can get updated dimension and DWG images, as well as installation instructions: